Skyworks Solutions Rf / Antenna Engineer Interview Questions
& Process
Real candidates share what happened, how many rounds they had,
and how the experience turned out.
Based on 27 interview experiences · FREE TO READ
Candidate interview experiences
First-hand accounts from people who interviewed at Skyworks Solutions.
Skyworks Solutions
RF Engineer
Intern Difficult Positive experience No offer 3 rounds
Interview process
Technical screen Technical screen Technical screen
Interview formats
Technical
it was very technical , was asked about rf fundamentals and no behavioural questions . focused a lot on rf coursework . 3 rounds all technical rounds with different engineers from skyworks in the department. they were all great.
Confirmed questions1 question
- What are s parameters and explain each of them
Skyworks Solutions
RF Engineer
Mid Average Neutral experience No offer 2 rounds
Interview process
Recruiter call Technical screen
Interview formats
Technical
The interview was virtual and I had a good experience. Round 1 was HR Screening. Round 2 was Technical. The recruiters were positive and made me comfortable while the whole process went.
Confirmed questions2 questions
- Can you explain the Smith chart?
- How do you approach impedance matching?
Skyworks Solutions
RF Engineer
Entry Average Positive experience No offer 2 rounds
Interview process
Group Technical screen
Interview formats
Group Technical
It was great, they asked me questions about Power amplifiers operation on how the envelope varies for ET or APT operation. Also about Cascaded noise figure and applications, typical system level design and budgeting power and noise figure trade off in designs. There were a lot of interviewers, and we had a group interview at the start which was tough.
Confirmed questions3 questions
- How does the envelope vary for ET or APT operation in Power amplifiers?
- Can you explain cascaded noise figure and its applications?
- Describe typical system level design and the trade-offs between power and noise figure in designs.
Skyworks Solutions Rf / Antenna Engineer Interview Questions
Quoted word for word from Skyworks Solutions interview reports.
“What are the basics of a smith chart, and what happens to the s parameters on it when an attenuator is present?”
Read reports →“Is this gain a voltage gain or a current gain?”
Read reports →“Can you tell me what the gain of a common base amplifier is?”
Read reports →“How does the envelope vary for ET or APT operation in Power amplifiers?”
Read reports →“What are the key considerations when designing an amplifier?”
Read report →“How are VNA and other equipment used?”
Read report →“Can you explain the basics of a smith chart, and what happens to the s parameters on it when an attenuator is present?”
Read report →“Can you explain the structure of a heterogen receiver?”
Read report →“What are the basics of Analog Circuits?”
Read report →Formats, difficulty and experience
Across all 27 Skyworks Solutions interview reports.