OmniVision Technologies Silicon / Chip Design Engineer Interview Questions
& Process
Real candidates share what happened, how many rounds they had,
and how the experience turned out.
Based on 8 interview experiences · FREE TO READ
Candidate interview experiences
First-hand accounts from people who interviewed at OmniVision Technologies.
OmniVision Technologies
Digital IC Design Engineer
Entry Average Positive experience No offer 2 rounds
Interview process
Recruiter call Phone screen
Interview formats
Technical Behavioral
It was a 1st phone screening. The questions were mostly based on my resume and asked about my backgrounds and coursework. The discussion was nice and the interviewer was patient and super good. No coding questions so far.
Confirmed questions2 questions
- Can you tell me about your background and coursework?
- Could you explain setup and hold time concepts?
OmniVision Technologies
Digital Design Engineer
Senior Easy Neutral experience No offer 2 rounds
Interview process
Technical screen Recruiter call
Interview formats
Technical Behavioral
The interview process consisted of two main parts. Initially, I had a technical discussion, followed by a session with HR. The technical questions were fairly straightforward for me, and I believe anyone with relevant experience would find them manageable. The HR conversation, however, was extensive and challenging for me. They focused on assessing my psychological attributes, teamwork capabilities, and mentoring skills. Unfortunately, my performance in the latter area did not impress HR, and they decided not to proceed further with my candidacy. I suspect my mindset and perhaps being too candid played a role. I'll definitely learn from this experience.
Confirmed questions3 questions
- Describe your past work experiences, highlighting challenges faced and how you overcame them.
- What is your understanding of synchronization theory?
- Can you elaborate on the principles of binary logic?
OmniVision Technologies
Digital Design Engineer
Mid Easy Neutral experience Accept offer 2 rounds
Interview process
Phone screen Onsite Offer
Interview formats
Technical Behavioral
I had a phone interview first, and then a few days later, I got invited for an on-site interview where I met with 6 people. Everyone was really friendly and the interview went smoothly. It wasn't too difficult, and they extended an offer the very next day.
Confirmed questions1 question
- Could you design a sequence detector for the sequence bala?
OmniVision Technologies Silicon / Chip Design Engineer Interview Questions
Quoted word for word from OmniVision Technologies interview reports.
“What are the differences between Moore and Mealy machines?”
Read reports →“Describe a two-stage op-amp.”
Read reports →“Can you explain synchronous versus asynchronous reset in Verilog?”
Read reports →“What is CDC?”
Read reports →“What about mux comparators?”
Read report →“What is hold time?”
Read report →“Can you explain a 5-transistor OTA?”
Read report →“Could you design a sequence detector for the sequence bala?”
Read report →“What is your understanding of synchronization theory?”
Read report →Formats, difficulty and experience
Across all 8 OmniVision Technologies interview reports.